Foam Cutter with Adjustable Heat

The Adjustable Heat Foam Cutter has a slippery work surface that is Alu Corbond compound making it easier to push Styrofoam around the large table. The solid aluminum over arm has a clearance of 5 1/2" for cutting Styrofoam blocks from 3/4" thick to 3" thick The holder and wire spool may be shifted and adjusted along the over arm to enable miter cutting
​ 

FEATURES

  • An LED indicates operation and thus reminds you not to touch the hot wire to prevent burnt fingers (the wire heats to the maximum temperature in less than 1 second)
  • Printed grid and protractor on worktable assist with division and cutting.
  • On/Off switch.
  • Electronic variable temperature control knob.
  • Lockable feed bar/fence for angle cuts.
  • One spool of NiChrome wire, 0.008" diameter x 98 ft L.
  • One year warranty​
​
​Item # VIP-869-910
  • This Item VIP-869-910 has no CE mark. UL Liisting or CSA Certification.
  • Item VIP-869-912 (230 Volt) has Approved CE mark only / No UL Listing.
NiChrome Wire
Picture
              NiChrome Wire,
​              0.008 inch diameter x 98 feet on spool

              Item # VIP-869-9101