ALUWAX - IMPRESSIONAL WAX

MAKE  A LASTING IMPRESSION . . .  A simple, yet effective method to use with your BITE BLOCK HEAD AND NECK IMMOBILIZATION SYSTEM. This dental wax (gray in color) is easy to form by heating in a water bath (or your room faucet water) 90° to 155°F. The wax may be used in sheet strip form or rolled into a mass. After softened, place around the bite piece and into the patient’s mouth. Setting time, 1–2 minutes. Sets hard—guaranteed you’ll like it!

Catalog#VIP-163           25 sheets/box

UTILITY WAX

This paraffin wax material is soft and pliable and can be molded into
the smallest detailed configuration. 
It comes packaged in a box of 55 square rope strips (11" x 3/16" x 3/16") and
is ready to use. Starting with one rope strip, and by adding rope to rope,
you can construct the shape you need without having to 
mix or melt a material/chemical. The wax will maintain its
shape as long as it isn’t pressured out of shape. 

Catalog #VIP-171   55 ropes/box white
Catalog #VIP-171R   55 ropes/box red

PINK DENTAL WAX

This wax may be used as bolus material, or used for coating eye shields. 1.6 mm thick.

Catalog #VIP-158                25 sheets/box 
                      Catalog #VIP-158-5               5 pound box                            

AQUAPLAST PELLETS

Soften these pellets quickly in hot water for easy shaping! 
Fabricate custom bite blocks and bolus with these easy to mold pellets.
Simply soften in hot water for less than 1 minute and contour—either directly
against the skin or a plaster or dental stone mold. 
Produces a rigid, unbreakable mold, which can be repeatedly modified by reheating.

Catalog# RT-7001 1 lb.
Catalog# RT-7003 3 lbs.

When forming bite blocks, place the softened pellets in a small plastic bag prior to inserting in the mouth. (DO NOT PLACE SOFTENED PELLETS DIRECTLY INTO THE MOUTH). 
Once the mold is completed and cooled, remove the plastic bag.